For a limited time, save 20 on the Top Carve set when purchased with any. Once the steps are cut, you then sand away the rough steps to end up with a beautifully carved top There are 5 step templates included. The PRS Top Carve template set is used with your router to cut 'steps' into the top of the body. PRS Top Carve Guide Templates.

I drilled a center pass and then angled the neck to either side and widened it as it gets closer to the nut. I used the boring feature on the Shopsmith to do this. I marked the open portion of the pocket templete to define the tenon on the neck heel.I neede to open up the access for the truss rod nut. The difference between there and the end of the neck pocket is the length of the tenon.1.5625'.I placed a light source under the templates and and slid them until the light just peeked out. And it pins into the trem mounting holes.I placed the neck template into the neck pocket template and pulle it to the nut side until it snugged up in the template.which was with it's end right at the nut side of the neck PU route. A major oversight by the template maker, in my opinion.Fortunately, he made the neck pocket template in a way that it lines up with 2 points on the body.the edge of the neck PU route and the PU side of the trem route.

Prs Guitar Template